LED Brightness Control using Light Dependent Resistors LDR

Components Required:

1) Breadboard

2) 1N4007 Diode

3) 470 ohm resistor

4) 15 Kilo ohm Light Dependent Resistor (LDR)

5) LED (Any Color)

6) 9Volt Battery

7) Digital Multimeter

Procedure:

Connect the 1N4007 diode and 470Ωresistor to one terminal of 15 Kilo ohm Light Dependent Resistor (LDR) in series. Connect the other terminal of LDR to the LED in series in a breadboard.

Connect the 9V battery's positive end to the anode of 1N4007 diode and negative end to the cathode of the LED as shown in the circuit diagram below.

Measure the voltage across various points by altering the Light input on the LDR using a digital multimeter and note the change in brightness of the LED accordingly.

Observe the change in LED brightness in a dark room and in a bright light. Here I have used a cap to cover the surface of the LDR to observe the change in LED brightness.

Also observe the change in resistance value of the LDR using a digital multimeter which is the cause for the alteration in LED brightness.

The resistance of LDR is low in bright light and high in darkness.

Circuit Diagram:

Figure 1: LED Brightness Control using Light Dependent Resistor (LDR) (LDR in Room Light)

Figure 2: LED Brightness Control using Light Dependent Resistor (LDR) (LDR covered with a cap)

Comments

Digital Fan Regulator Circuit Diagram

This is the project of Digital Fan Regulator Circuit diagram. The circuit presented here can be used to control the speed of fans using induction motor. The speed control is nonlinear, i.e. in steps. The current step number is displayed on a 7-segment display. Speed can be varied over a wide range because the circuit can alter the voltage applied to the fan motor from 130V to 230V RMS in a maximum of seven steps. The triac used in the final stage is fired at different angles to get different voltage outputs by applying short-dura-tion current pulses at its gate. For this pur-pose a UJT relax-ation oscillator is used that outputs sawtooth waveform. This waveform is coupled to the gate of the triac through an optocoupler (MOC3011) that has a triac driver output stage. Pedestal voltage control is used for varying the firing angle of the triac. The power supply for the relaxation oscillator is derived from the rectified mains via 10-kilo-ohm, 10W series dropping/limit-ing resistor R2.

Home automation with Telegram BOT

The project I’m going to describe today it’s a sort of proof of concept that will demonstrate the possibility to remote control sensors and actuators (for example a couple of relays) via Telegram. Telegram is an instant messaging application, similar to the famous Whatsapp. Last June, the Telegram developers announced that a new set of APIs were available to develop bots. [ ]

Circuit Cat And Dog Repellent

The electronic dog repellent circuit diagram below is a high output ultrasonic transmitter which is primarily intended to act as a dog and cat repeller, which can be used individuals to act as a deterrent against some animals. It should NOT be relied upon as a defence against aggressive dogs but it may help distract them or encourage them to go away and do not consider this as an electronic pest repeller. The ultrasonic dog repellant uses a standard 555 timer IC1 set up as an oscillator using a single RC network to give a 40 kHz square wave with equal mark/space ratio. This frequency is above the hearing threshold for humans but is known to be irritating frequency for dog and cats. Since the maximum current that a 555 timer can supply is 200mA an amplifier stage was required so a high-power H-bridge network was devised, formed by 4 transistors TR1 to TR4. A second timer IC2 forms a buffer amplifier that feeds one input of the H-bridge driver, with an inverted waveform to that of IC1 ou

ffd

Search This Blog