ffd

Tone control circuit is used to adjust the tones before entering the amplifier. Tone control over equipped with a loudness and filter directly without using the switch to disconnected or connected. Part of his filter that is C1 and R1 from ground to input , and for his loudness on the R4 and C3 are connected to the input and then go to VR1. C2 and R3 go from ground to the input . After the input is set by volume or VR1 then procesed again by treebel ie C8 , R13 , R14 , and VR2 . Bass on R10 , R11, R12 , C7 ,C8 , and VR3. For supply voltages has been given a stabilization in Q3. See schematic below : Click to view larger Part list : R1 = 100K R2 = 50K trim R3 = 22K R4 = 15K R5 = 1K R6 = 4K7 R7 = 330K R8 = 330K R9 = 3K3 R10= 5K6 R11= 8K2 R12= 5K6 R13= 1K R14= 1K R15= 50K TRIM R16= 50K TRIM R17= 330K R18= 4K7 R19= 47K R20= 1K R21= 4K7 R22= 2K2 R23= 100R R24= 22K C1 = 15n C2 = 15n C3 = 560p C4 = 4u7 C5 = 33u C6 = 4n7 C7 = 39n C8 = 39n C9 = 4u7 C10=4u7 C11=470u C12=100u Q1 = C1815 Q2 = C828...

The treble control works in a similar manner as the bass control elsewhere in this site, but contains several modifications, of course. One of these is the series network C1-C2– R1– R1 1. The d.c. operating point of IC3 is set with resistors R12 and R13. To ensure that these resistors do not (adversely) affect the control characteristics, they are coupled to the junction of R9 and R1 0. In this way they only affect the low-frequency noise and the load of the opamp. Their value of 10 kΩ is a reasonable compromise. The functions of switches S1– S3 are identical to those of their counterparts in the bass tone control; their influence is seen clearly in the characteristics. Circuit diagram: Treble Tone Control Circuit Diagram Good symmetry between the left-hand and right-hand channels is obtained by the use of 1% versions of R1– R1 3 and C1, C2. The value of resistors R2– R1 0 is purposely different from that of their counterparts in the bass tone control. In the present circuit, the cont...

This is the tone booster schematic diagram which is published on Everyday Electronics, September 1978 edition. The peaks of frequencies is at 5000 Hz for a “cleaner and more penetrating” sound. The Q1 type is ztx384, while the Q2 is BC415p.  Simple Tone Booster Schematic Diagram

This a stereo tone control circuit built using LM1036 IC . This control circuit bass / treble tone level, volume and balance between the right channel and left channel (Input 1 and 2). You can use this circuit for stereo applications such as car radio, television and audio systems, MP3 player, DVD player, ipod and more. An additional control input allows loudness compensation to be made simply. The circuit must be working with a supply voltage of 9V to 15V DC. Each tone response is defined by a single capacitor chosen to give the desired characteristic. By changing the values ​​of capacitors connected to the tone control unit, you can control bass and treble levels. pin 3 and pin 18 of IC are for acute and pin 6 to pin 15 for bass.