ffd

This digital SP tachometer for bikes uses 2 reed switches to urge the speed data of the bicycle. The reed switches are put in close to the rim of the wheel where permanent magnets pass by. The permanent magnets are connected to the wheelspokes and activate the reed switches everytime they pass by it. The speed is digitally displayed. The tachometer circuit works in step with this principle; the pulses created by the reed contacts are counted inside an explicit time interval. The ensuing count is then displayed and represents the speed of the bike. 2 4026 ICs are used to count the pulses, decode the counter and management 2 7-segment LED show. RS flip-flops U3 and U4 perform as anti-bounce. Electronic bicycle SP tachometer circuit diagram The pulses arrive at the counter’s input through gate U7. The measuring amount is set by monostable multivibrator U5/U6 and might be adjusted through potentiometer P1 so the tacho are often calibrated. The circuit U1/U2 resets the counters. Since batte...

The above circuit is a circuit of motor bike horn .This circuit can be operated from 4.5V to 12VDC  or direct from the brake point of motor bike.Resistor R 7 should be replaced with 1-ohm. 1/2W in case of an 8-ohm speaker. T 5 is a driver transistor. C 3 polarity can be reversed for a sudden off of the circuit. PARTS LIST Resistors (all ¼-watt, ± 5% Carbon) R1, R7 = 2.2 KΩ R2, R4 = 820 Ω R3, R5 = 470 Ω R6 = 4.7 KΩ R8 = 10 KΩ R9 = 4.7 Ω, 0.5W Capacitors C1 = 22 µF/25v C2 = 4.7 µF/63V C3 = 100v/16V C4 = 0.047 µF C5 = 0.01 µF Semiconductors T1 – T4 = BC148B T5 = SL100 Miscellaneous LS1 = 4Ω speaker

This digital DIY tachometer for bikes uses two reed switches to get the speed information of the bicycle. The reed switches are installed near the rim of the wheel where permanent magnets pass by. The permanent magnets are attached to the wheelspokes and activate the reed switches everytime they pass by it. The speed is digitally displayed. The tachometer circuit works according to this principle; the pulses created by the reed contacts are counted within a certain time interval. The resulting count is then displayed and represents the speed of the bike. Two 4026 ICs are used to count the pulses, decode the counter and control two 7-segment LED display. RS flip-flops U3 and U4 function as anti-bounce. Electronic bicycle DIY tachometer Circuit diagram: The pulses arrive at the counter’s input through gate U7. The measuring period is determined by monostable multivibrator U5/U6 and can be adjusted through potentiometer P1 so that the tacho can be calibrated. The circuit U1/U2 resets the ...